Techtalk

Almost forgot:

[silent:arts] hat geschrieben: where did you buy the cases ? I like the ventilation holes.

I bought them from Modushop in Italy. Great cases for a very nice price.

Waldorfcave, this combination wasn't used on any of my projects yet. I always try to make my gear a bit different looking, i don't like having rack fulls of gear which looks the same.

Flo

Infernal_Death hat geschrieben:I bought them from Modushop in Italy. Great cases for a very nice price.

Thanks Flo.
just ordered two 3U cases with the extra ventilation tops there.
anybody wants the front pannels ?

Volker,
if there is a black one, I´ll take it.
regards
Bernd

bernbrue hat geschrieben:if there is a black one, I´ll take it.

mhm, since silver was less expensive it is silver,
but you can have it anyway

If Bernd needs only one, and the other is still left, I would have a use for the other...

Kann mir jemand in deutsch und für blöde mal den Unterschied zwischen normalen t4b und der "fast" Version erklären?

Ist letztere besser für Percussion bzw. halt Sachen mit knackiger Attack-Phase geeignet?

Hi All,

(my first post here)

Re the 2LA2, Meter switch - GR / Output +4,

on the PCB labelled GAIN RED its has a 2 contact plug, but on the circuit diagram shows a double pole switch, how are you doing this with only two contacts?

Is there a PCB Layout Drawing with the PCB tracks drawn?

all the best

Pete

Hi Pete,

welcome here at Franks place

you have the GR connector (2 contacts), and you have a separated VU connector (2 contacts). you wire both to a 2 pole toggle switch, and from there (through a 3K6 resistor at +) to the Meter.

does this answer your question ?

ah! i knew i was being stupid! of course yes im with you now.


Also I was thinking about bringing the Zero Adj and the Stereo Adj to the front panel for easy adjustment, do you fore see a problem with this, as long as the cable is shielded should be fine?

Thanks Volker,
Pete

I see no problem doing this

Hey Volker

I have a couple of questions to finish mine up.

- which side is the + on the VU and Gain red outputs?
- What are those diodes strapped across the relays?
- Earlier you mentioned the pots are all one-to-one mapping but what is pin 1 and pin3 , relative to the screw in the screen?

I will fire mine up tonight I think!

-Chuck

see above question ... double post

ChuckD hat geschrieben:- which side is the + on the VU and Gain red outputs?

red? don't really understand this question

ChuckD hat geschrieben:- What are those diodes strapped across the relays?

1N4148

ChuckD hat geschrieben:- Earlier you mentioned the pots are all one-to-one mapping but what is pin 1 and pin3 , relative to the screw in the screen?

looking IN FRONT of the molex = 1 (left) 2 (middle) 3 (right)
in example, the gain pot:
put it on the left side, facing the pins downside, looking to the molex, wire it 1:1

hope this helps

fire it up

Basically the +/- on the VU or Gain Reduction meter pins
Also the following labels. Think I understand what you mean but a picture is better

I keep getting logged out ! Anyway sorry here is the one I meant to post